ZyXEL Communications 310 User Manual page 482

Chapter 37 System
Figure 333 Configuration > System > SNMP
The following table describes the labels in this screen.
Table 191 Configuration > System > SNMP
LABEL
Enable
Server Port
Get Community
Set Community
Trap
Community
Destination
Service Control
Add
Edit
Remove
Move
482
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Service Control table to access the ZyWALL using this service.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Enter the Set community, which is the password for incoming Set requests from the
management station. The default is private and allows all requests.
Type the trap community, which is the password sent with each trap to the SNMP manager.
The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
This specifies from which computers you can access which ZyWALL zones.
Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry. Refer to
Double-click an entry or select it and click Edit to be able to modify the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms you want to remove
it before doing so. Note that subsequent entries move up by one when you take this action.
To change an entry's position in the numbered list, select the method and click Move to
display a field to type a number for where you want to put it and press [ENTER] to move
the rule to the number that you typed.
Table 185 on page 461 for details on the screen that opens.
ZyWALL 110/310/1100 Series User's Guide