ZyXEL Communications 310 User Manual page 193

Figure 110 Configuration > Network > Routing > Policy Route > Add/Edit (IPv6 Configuration)
The following table describes the labels in this screen.
Table 68 Configuration > Network > Routing > Policy Route > Add/Edit
LABEL
Show Advanced
Settings / Hide
Advanced Settings
Create new Object
Configuration
Enable
Description
Criteria
User
Incoming
Source Address
Destination Address
ZyWALL 110/310/1100 Series User's Guide
DESCRIPTION
Click this button to display a greater or lesser number of configuration fields.
Use this to configure any new settings objects that you need to use in this screen.
Select this to activate the policy.
Enter a descriptive name of up to 31 printable ASCII characters for the policy.
Select a user name or user group from which the packets are sent.
Select where the packets are coming from; any, an interface, a tunnel, an SSL VPN, or
the ZyWALL itself. For an interface, a tunnel, or an SSL VPN, you also need to select
the individual interface, VPN tunnel, or SSL VPN connection.
Select a source IP address object from which the packets are sent.
Select a destination IP address object to which the traffic is being sent. If the next hop
is a dynamic VPN tunnel and you enable Auto Destination Address, the ZyWALL
uses the local network of the peer router that initiated an incoming dynamic IPSec
tunnel as the destination address of the policy instead of your configuration here.
Chapter 9 Policy and Static Routes
193