Identifying The Breakers; Pdu/Rpp Breakers - Eaton Power Xpert 1000 Series User Manual

MODBUS REGISTERS

Identifying the Breakers

Panel Position Breaker #
1 01
3
5
03
7
9 09
11
13
15 15
17
56 EATON Power Xpert
To identify the breakers in a PDU/RPP panel, see the following section.
To identify the breakers in an RPM, see "RPM Breakers" on page 57.

PDU/RPP Breakers

A PDU/RPP panel can contain a mix of single-, two-, or three-pole
breakers. Each pole takes one position (or slot) in the panel.
Figure 33 shows a partial map of a panel with a mix of breaker sizes.
Unoccupied positions are shown in gray. Odd numbered positions are on
the left and even numbered positions are on the right.
Breaker
Phase
Rating
20
50
20
20
Figure 33. Sample PDU/RPP Panel Map
A single-pole breaker occupies one position; a two-pole breaker occupies
two positions; and a three-pole breaker occupies three positions. The
breaker number corresponds to the position in the panel. For example,
Breaker 01 is in position 1 and is a single-pole, 20A breaker connected to
Phase A. Breaker 02 is in position 2 and is a single-pole, 20A breaker
connected to Phase A.
® Gateway Series 1000 Card User's Guide
Breaker
Rating
A 20
B 20
C 20
A
40
B
C
A
B
C
S
164201670 Rev 4
Breaker # Panel Position
02 2
04 4
06 6
8
08
10
12
14
16
18
www.eaton.com/powerquality