Network Configuration - Eaton Power Xpert 1000 Series User Manual

GETTING STARTED

Network Configuration

18 EATON Power Xpert
If you know the card's IP address, you can configure the network
settings from the card's Web page:
1. Open a Web browser, type the IP address of the card, and select
Go.
2. Log in as admin and press Enter. The user name and default
password is user for read-only information and admin for
configuration (read/write) options.
The PXGX Series 1000 Card Web page opens (see Figure 18).
Figure 18. PXGX Series 1000 Card Web Page
3. Select the Network link from the menu bar.
The Network Configuration Settings page appears. The page shows
the current network status for each port on the card (green
indicates the network is connected; red indicates the network is
disconnected).
4. You can enable or disable the DHCP control by activating or
deactivating the check box. The default is DHCP enabled.
® Gateway Series 1000 Card User's Guide
S
www.eaton.com/powerquality
164201670 Rev 4