Assigning Ip Addresses (Dhcp Disabled) - Eaton Power Xpert 1000 Series User Manual

EATON Power Xpert
® Gateway Series 1000 Card User's Guide

Assigning IP Addresses (DHCP Disabled)

NOTE You can also set network settings via the PXGX Series 1000 Card's Web page
Network link (see "Network Configuration" on page 18).
To manually enter fixed IP addresses for the card after you have
connected it:
1. Type 1 and press Enter on the Network Settings menu (see
Figure 10) to display the Network Settings: Ethernet Port 1 menu
(see Figure 11).
------------------------------------------------------------------
---------- Network Settings: Ethernet Port 1 ----------
------------------------------------------------------------------
1. Dynamic Addressing (DHCP) : Enabled
2. IP Address
3. Subnet Mask
4. Default Gateway
5. Media Type
MAC Address
Link Status
0. Exit to previous menu
Select an option ==>
---------------------------------------------------------
---------------- Network Settings ----------------
---------------------------------------------------------
1. Ethernet Port 1 Settings
2. Ethernet Port 2 Settings
3. DNS Server (Primary) : [None]
4. DNS Server (Secondary) : [None]
5. Reset to Factory Defaults and Exit
0. Exit
Select an option ==> 1
Figure 10. Network Settings Menu
: [None]
: [None]
: [None]
: [Auto-negotiate]
: 00:60:26:10:89:A8
: Enabled
Figure 11. Ethernet Port 1 Menu
S
www.eaton.com/powerquality
164201670 Rev 4
GETTING STARTED
13