Restricting Snmp Access - Eaton Power Xpert 1000 Series User Manual

EATON Power Xpert
® Gateway Series 1000 Card User's Guide
4. Click Apply and then OK to save the settings.
5. Repeat Steps 3 and 4 for each additional trap recipient.
To remove a trap recipient, click Delete Last. Click OK when
prompted to remove the settings for the trap recipient entered last.

Restricting SNMP Access

The factory-default is to limit access to the card to trusted SNMP NMS
hosts only.
To restrict access:
1. From the card's Web page, click the Access Control link from the
menu bar.
2. Activate the check box for SNMP access restricted by IP/hostname.
3. Type the trusted NMS host's IP addresses or host names,
separated by a semicolon, in the Trusted IPs/hostnames field.
NOTE When using host names, verify that the IP address of your network DNS Server is
configured (see "Network Configuration" on page 18).
4. Click Apply and then OK to save the settings.
S
www.eaton.com/powerquality
164201670 Rev 4
CONFIGURING THE CARD
27