Configuring Modbus Tcp/Ip Options - Eaton Power Xpert 1000 Series User Manual

MIB Name
RFC 4133 Entity MIB
RFC 4268 Entity State MIB
RFC 4268 Entity State MIB Part 2

Configuring Modbus TCP/IP Options

EATON Power Xpert
® Gateway Series 1000 Card User's Guide
Filename
ENTITY-MIB.txt
ENTITY-STATE-MIB.txt
ENTITY-STATE-TC-MIB.txt
Add these files to the MIB database of your SNMP management
software (such as HP OpenViewt, IBM
NetManager).
3. Use the facilities provided by the SNMP management software to
access the individual MIB objects. See Chapter 5, "MIB Files," on
page 51 for more information.
To limit access to the card from trusted TCP/IP addresses only:
1. From the card's Web page, click the Access Control link from the
menu bar.
2. Activate the check box for Modbus-TCP access restricted by
IP/hostname.
3. Type the trusted host's IP addresses or host names, separated by a
semicolon, in the Trusted IPs/hostnames field.
NOTE When using host names, verify that the IP address of your network DNS Server is
configured (see "Network Configuration" on page 18).
NOTE If the SMTP server does not use Port 25, append the port to the IP address (for
example, mysmtpserver:33).
4. Click Apply and then OK to save the settings.
For information on Modbus registers, see Chapter 6, "Modbus
Registers," on page 55.
Description
Identification and description of each device
attached to the card
Five availability status meters for each
device attached to the card
Possible state values for the Entity State MIB
®
S
www.eaton.com/powerquality
164201670 Rev 4
CONFIGURING THE CARD
Director, and Sun
29