Connecting The Card - Eaton Power Xpert 1000 Series User Manual

Connecting the Card

EATON Power Xpert
® Gateway Series 1000 Card User's Guide
To connect the card to the computer and start the configuration:
1. Plug the RJ-45 end of the supplied configuration cable into the
configuration port on the card labeled "10101" (see Figure 4).
NOTE Verify that you have used the port labeled "10101." The other ports on the card do
not work for configuration.
2. Plug the other end of the serial cable into the serial COM port on
the computer.
3. Open your terminal emulation program (such as HyperTerminal).
Figure 4. Install Configuration Cable
S
www.eaton.com/powerquality
164201670 Rev 4
GETTING STARTED
7