Verifying Ip Addresses (Dhcp Enabled) - Eaton Power Xpert 1000 Series User Manual

* If the IP address field contains [None], press Enter to return to the Network Settings menu and wait 60 seconds.
Repeat Steps 1 through 8. If the field remains [None], contact the local network administrator to verify that the
DHCP server is responding to requests.
EATON Power Xpert
® Gateway Series 1000 Card User's Guide

Verifying IP Addresses (DHCP Enabled)

To verify the IP address assignments:
1. Type 1 and press Enter on the Network Settings menu (see Figure 7
on page 9) to display the Network Settings: Ethernet Port 1 menu
(see Figure 8).
------------------------------------------------------------------
---------- Network Settings: Ethernet Port 1 ----------
------------------------------------------------------------------
1. Dynamic Addressing (DHCP) : Enabled
2. IP Address
3. Subnet Mask
4. Default Gateway
5. Media Type
MAC Address
Link Status
0. Exit to previous menu
Select an option ==>
2. Verify and record the IP address for Port 1* (see "Installation
Checklist" on page 3).
3. Type 0 and press Enter to return to the Network Settings menu.
4. If you connected Ethernet Port 2 to a separate network, continue to
Step 5 to verify the assigned IP address. Otherwise, continue to
Step 8.
5. Type 2 and press Enter on the Network Settings menu to display the
Network Settings: Ethernet Port 2 menu.
6. Verify and record the IP address for Port 2* (see "Installation
Checklist" on page 3).
7. Type 0 and press Enter to return to the Network Settings menu.
8. Type 0 and press Enter to exit the utility.
: 10.222.51.250
: 255.255.255.0
: 10.222.51.254
: [Auto-negotiate]
: 00:60:26:10:89:A8
: Enabled
Figure 8. Ethernet Port 1 Menu
S
www.eaton.com/powerquality
164201670 Rev 4
GETTING STARTED
11