9P – 18IDOORS
Installation Procedure
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
1.
Install the rear door lock with the screws.
Tighten
Tighten the rear door lock screws to 10 NSm (89 lbin).
2.
Connect the electrical connector.
3.
Install the guide rail with the screw.
4.
Connect the outside door handle and the lock rods.
5.
Connect the inside door handle and the lock rods.
6.
Install the door seal trim. Refer to"Door Seal Trim"
in this section.
7.
Connect the negative battery cable.
DAEWOO V–121 BL4