Daewoo Nubira User Manual page 271

GENERAL DESCRIPTION
AND SYSTEM OPERATION
DRIVING MEMBERS
The driving members consist of two flat surfaces ma-
chined to a smooth finish. One of these is the rear face of
the engine flywheel, and the other is the pressure plate.
The pressure plate is fitted into a steel cover, which is
bolted to the flywheel.
DRIVEN MEMBERS
The driven member is the clutch disc with a splined hub
DAEWOO V–121 BL4
which is free to slide lengthwise along the splines of the in-
put shaft, but which drives the input shaft through these
same splines.
The driving and driven members are held in contact by
spring pressure. This pressure is exerted by a diaphragm
spring in the pressure plate assembly.
OPERATING MEMBERS
The clutch release system consists of the clutch pedal, the
clutch shaft, the fork, and the release bearing. When pres-
sure is applied to the clutch pedal, the fork pivots on its
shaft and the inner end pushes against the release bear-
ing. The bearing then pushes against the release levers in
the pressure plate assembly, thereby releasing the clutch.
CLUTCH 5C0 – 25