Daewoo Nubira User Manual page 61

9P – 6IDOORS
Step
12 Repair the open circuit between terminal 3 of the
power door lock relay and splice pack S302, or be-
tween terminal 5 of the door lock relay and splice
pack S301.
Is the repair complete ?
13
1. Raise the power window in the driver's side
door.
2. Disconnect the central lock switch connector at
the top of the door lock. (There are three con-
nectors on the door lock. Use the schematic to
verify the correct connector.)
3. Use an ohmmeter to check the continuity be-
tween terminal B (BLK) of the central lock
switch connector and ground.
Is the continuity equal to the specified value ?
14 Repair the open circuit between the central lock
switch connector terminal B (BLK) and ground.
Is the repair complete ?
15
1. Make sure the lock relay connector is con-
nected.
2. Touch a grounded jumper wire to terminal A
(LT BLU) of the disconnected central lock
switch connector.
3. Remove the grounded jumper wire and touch it
to terminal C (WHT) of the disconnected cen-
tral lock switch connector.
Do the doors lock and unlock when terminals C and
A are alternately grounded ?
16
1. Make sure all the lock rods are connected to
the driver's side door lock.
2. If no disconnected lock rods are found, replace
the driver's side door lock with the integral door
lock switch. ( Do not confuse the door lock with
the lock cylinder. The door lock has three con-
nectors:the lock switch, the lock solenoid, and
the door contact switch. Use the schematic to
verify the correct connector.)
Is the repair complete ?
17 Use an ohmmeter to check the continuity between
terminal A (LT BLU) of the disconnected central lock
switch connector and terminal 4 (LT BLU) of the
power door lock relay connector.
Is the continuity equal to the specified value ?
18 Repair the open LT BLU wire.
Is the repair complete ?
19 Use an ohmmeter to check the continuity between
terminal C (WHT) of the disconnected central lock
switch connector and terminal 8 (WHT) of the door
lock relay connector.
Is the continuity equal to the specified value ?
Action Value(s) Yes
System OK
[ 0 W
Go toStep 15
System OK
Go toStep 16
System OK
[ 0 W
Go toStep 19
System OK
[ 0 W
Go toStep 21
No
Go toStep 14
Go toStep 17
Go toStep 18
Go toStep 20
DAEWOO V–121 BL4