Daewoo Nubira User Manual page 151

9O – 12IBUMPERS AND FASCIAS
REAR BUMPER IMPACT BAR
(Notchback Shown, Hatchback and
Wagon Similar)
Removal Procedure
1. Remove the rear bumper fascia. Refer to"Rear
Bumper Fascia" in this section.
2. Remove the rear bumper energy absorber. Refer
to"Rear Bumper Energy Absorber" in this section.
3. Reposition the luggage compartment floor carpet.
4. Remove the plastic caps to reveal the impact bar
bolts.
5. Remove the bolts securing the impact bar.
6. Remove the impact bar from the vehicle.
7. Remove the nuts and the impact bar brackets from
the impact bar.
8. Remove the screws and the rear fascia brackets
from the impact bar.
Installation Procedure
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
1. Install the rear fascia brackets to the impact bar
with the screws.
2. Install the impact bar brackets to the impact bar
with the nuts.
Tighten
Tighten the rear impact bar bracket nuts to 30 NSm
(22 lb–ft).
DAEWOO V–121 BL4