Daewoo Nubira User Manual page 650

DAEWOO V–121 BL4
AUTOMATIC TRANSAXLE DRIVE AXLE 3A – 9
4. Install a new large seal retaining clamp and a new
small seal retaining clamp.
5. Crimp the new small seal retaining clamp and the
new large seal retaining clamp using the seal clamp
pliers J–35566.
6. Install the drive axle shaft to the vehicle. Refer
to"Drive Axle Assembly" in this section.
INNER TRIPOT SEAL
Tools Required
J–8059 Snap Ring Pliers
Removal Procedure
1. Remove the drive axle from the vehicle. Refer
to"Drive Axle Assembly" in this section.
2. Remove the large seal retaining clamp. Discard the
clamp.
3. Remove the small seal retaining clamp. Discard the
clamp.