Daewoo Nubira User Manual page 26

Description
Remote Keyless Entry Programming
8. From the CODING SYSTEM screen, select "Coding Only" by pressing #1 on the Key
Pad.
9. From the SECRET NUMBER OF CODINGS screen, enter four (4) zero's (0-0-0-0) in the
four (4) boxes labeled "1-2-3-4".
10. From the CODING SYSTEM SELECT screen, select "Keyless Entry" by pressing #2 on
the Key Pad.
Note: A slight delay may occur and "PLEASE WAIT" may be displayed before the next
screen appears.
11. From the KEYLESS ENTRY CODING SYSTEM screen, select "Coding Transmitter" by
pressing #1 on the Key Pad.
12. When directed by the Scan 100 Scan Tool, press any Button on the first Transmitter to
be programmed.
CAUTION: Ensure that Transmitters from other vehicles in the immediate area are not
activated during this procedure.
13. Continue programming Transmitters when directed by the Scan 100 Scan Tool until all
Transmitters have been programmed.
Note: A maximum of five (5) Transmitters may be programmed to a vehicle.
14. Once all Transmitters have been programmed, press the "ESC" Button on the Key Pad.
The display will confirm the number of Transmitters programmed. If the number
displayed does not match the number of Transmitters programmed, repeat the procedure.
15. Turn the Scan 100 Scan Tool "OFF" by pressing the "POWER" Button, then disconnect it
from the Data Link Connector.
16. Wait approximately 10 seconds, then test the operation of each programmed Transmitter
to ensure it operates properly.
If additional information is needed regarding this procedure, please contact your District Parts
& Service Manager or the Daewoo Technical Assistance Center toll free at (877) 362-1234,
selection 1.
May, 2001
Page
2 of 2