Daewoo Nubira User Manual page 603

1F – 400IENGINE CONTROLS
Installation Procedure
1. Connect the PCM/ECM connectors to the PCM/
ECM.
2. Insert and align the PCM/ECM into the mounting
base.
3. Insert the retaining clip lower end into the mounting
base.
4. Connect the retaining clip to the mounting base.
5. Install the passenger side kick panel. Refer to Sec-
tion 9G, Interior Trim.
6. Connect the negative battery cable.
7. Perform a crankshaft position system variation
learning procedure. Refer to " DTC P1336 " in this
section.
ELECTRONIC IGNITION SYSTEM
IGNITION COIL
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the electronic ignition (EI) system igni-
tion coil connector.
3. Note the ignition wire location and remove the igni-
tion wires.
4. Remove the EI system ignition coil retaining bolts.
5. Remove the EI system ignition coil.
Installation Procedure
1. Install the EI system ignition coil into the mounting
location and install the retaining bolts.
Tighten
Tighten the electronic ignition system ignition coil re–
taining bolts to 89 lb–in (10 NSm).
2. Connect the EI system ignition coil connector.
3. Install the ignition wires.
4. Connect the negative battery cable.
DAEWOO V–121 BL4