Daewoo Nubira User Manual page 482

DAEWOO V–121 BL4
DOHC ENGINE MECHANICAL 1C – 87
47. Install the timing belt. Refer to "Timing Belt" in this
section.
48. Adjust the timing belt tension. Refer to "Timing Belt
Check and Adjust" in this section.
49. Apply a small amount of gasket sealant to the cor-
ners of the front camshaft caps and to the top of
the rear valve cover to cylinder head seal.
50. Install the valve cover and the valve cover gasket.
51. Install the valve cover washers.
52. Install the valve cover bolts.
Tighten
Tighten the valve cover bolts to 8 NSm (71 lb–in).
53. Connect the ignition wires to the spark plugs.
54. Install the spark plug cover.
55. Install the spark plug cover bolts.
Tighten
Tighten the spark plug cover bolts to 8 NSm (71 lb–in).
56. Connect the crankcase breather tube to the valve
cover.
57. Install the front timing belt cover.
58. Install the front timing belt cover bolts.
Tighten
Tighten the front timing belt cover bolts to 6 NSm (53
lb–in).
59. Install the engine lifting device.
60. Remove the engine from the engine overhaul stand
KM–412.
61. Install a new crankshaft rear oil seal using installer
J–36972 (or KM–635).