DAEWOO V–121 BL4
WIPERS/WASHER SYSTEMS 9D – 21
Installation Procedure
1.
Connect the electrical connector.
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
2.
Install the rear wiper motor with the bolts.
Tighten
Tighten the wiper motor bolts to 8 NSm (71 lb–in).
3.
Install the hatchback door lower garnish molding.
Refer toSection 9G, Interior Trim.
4.
Install the rear window wiper arm. Refer to "Rear
Window Wiper Arm" in this section.
5.
Close the wiper arm access cap.
REAR WINDOW WIPER MOTOR
(WAGON)
Removal Procedure
1.
Disconnect the negative battery cable.
2.
Remove the rear window wiper arm. Refer to "Rear
Window Wiper Arm" in this section.
3.
Remove the wiper motor exterior retaining clip and
nut from the tailgate.
4.
Remove the tailgate lower garnish molding.
5.
Disconnect the electrical connector and the washer
hose.
6.
Remove the bolts and the rear wiper motor.