Daewoo Nubira User Manual page 649

3A – 8IAUTOMATIC TRANSAXLE DRIVE AXLE
UNIT REPAIR
OUTER JOINT SEAL
Tools Required
J–8059 Snap Ring Pliers
Removal Procedure
1. Remove the drive axle from the vehicle. Refer
to"Drive Axle Assembly" in this section.
2. Remove the large seal retaining clamp. Discard the
clamp.
3. Remove the small seal retaining clamp. Discard the
clamp.
4. Degrease the joint.
5. Spread the snap ring using the snap ring pliers
J–8059 and remove the outer joint from the axle
shaft.
CAUTION : Do not disassemble the outer joint assem-
bly. Parts are match fit and cannot be serviced sepa-
rately. Improper reassembly will adversely affect both
performance and safety.
6. Remove the seal from the joint assembly.
Installation Procedure
Tools Required
J–35566 Seal Clamp Pliers
1. Install the seal onto the axle shaft.
2. Spread the snap ring using the snap ring pliers
J–8059 and install the outer joint onto the axle
shaft.
3. Fill the joint seal with 175 to 195 g (6.2 to 6.9
ounces) of the recommended grease. Repack the
joint with 175 to 195 g (6.2 to 6.9 ounces) of the
recommended grease.
DAEWOO V–121 BL4