Daewoo Nubira User Manual page 336

9B – 26ILIGHTING SYSTEMS
Step
15 Repair the open circuit between the hazard switch
and fuses F3 or EF12.
Is the repair complete?
16 With the hazard switch disconnected, use an ohm-
meter to check for an open circuit between blinker
unit terminal 49 and hazard switch connector termi-
nal 7.
Is there an open circuit?
17 Repair the open circuit between the hazard switch
and the blinker unit.
Is the repair complete?
18
1. Remove the hazard switch.
2. Turn the hazard switch OFF.
3. Use an ohmmeter to check for continuity be-
tween terminals 7 and 10.
4. Turn the hazard switch ON.
5. Use an ohmmeter to check for continuity be-
tween terminals 7 and 8.
Does the ohmmeter show the specified value for
both tests?
19 Replace the hazard switch.
Is the repair complete?
20
1. With the hazard switch still removed for testing,
turn the hazard switch to the ON position.
2. Use an ohmmeter to check the continuity be-
tween terminals 5, 6, and 9.
Is there continuity between terminals 5, 6, and 9?
21
1. Disconnect connector C204.
2. Use an ohmmeter to check the continuity of the
wire between the hazard switch terminal 5 and
C204 terminal 1.
Does the ohmmeter show the value specified?
22 Repair the open wire between the hazard switch and
C204.
Is the repair complete?
23 Use an ohmmeter to check the continuity of the wire
between the hazard switch terminal 6 and C204 ter-
minal 11.
Does the ohmmeter show the specified value?
24 Repair the open circuit between C204 and the turn
signal bulbs.
Is the repair complete?
Action Value(s) Yes
System OK
Go to Step 17
System OK
0 W
Go to Step 20
System OK
Go to Step 19
R
Go to Step 23
System OK
R
Go to Step 24
System OK
No
Go to Step 18
Go to Step 19
Go to Step 21
Go to Step 22
Go to Step 22
DAEWOO V–121 BL4