Changing the initial operating mode on a Network Copier
If the Océ 31x5E Network Copier is used mainly for printing or scanning, you
may decide to set the print or scan mode as the initial mode. In that case,
Network Copier users must switch to the copy mode first before they can make
a copy. And, of course, if the Network Copier is used mainly for copying, you
should set the initial operating mode to copying.
Depending on the selected mode, you may want to change the time delay
Note:
for switching to default mode (see 'Defining the reset time for settings' on
page 31).
[12] Initial operating mode set to copying
[13] Initial operating mode set to printing
Configuration management
29