Table of Contents
Advertisement
Defining the automatic switch off time and
sleep time
If the copier is not used for a longer time, it will switch off (DC / Classic) or
go to sleep mode (NC / Eco). The sleep mode can be recognized by the special
screen on the display of the operating panel. The copier is not kept on operating
temperature. Copying will be possible after 30 seconds to 8 minutes. The auto
switch off time or sleep time is set by default to 90 minutes, in order to comply
with the EPA Energy Star criteria (see page 140). This setting can be changed
to any time between 10 and 90 minutes.
The machine will automatically switch off or go to sleep mode (Eco only)
Note:
after the specified time. However, if a user takes any action during this time
(such as placing an original, opening a door or pressing a button) the timer is
reset and starts counting again.
You can wake up the machine from sleep mode by sending an automatic print
job or by pressing a button on the console. The energy saving screen will
disappear. The message 'Please wait' or 'Warming up' will show before
'Ready to copy' appears again.
If the copier (DC) is switched off automatically, you have to turn on the
machine by the green on/off button.
Changing the automatic switch off time (digital copier)
Access the key operator system (see page 14).
1
Open the 'Machine' section and select the 'Basic' settings.
2
Press the 'Power saving' function button once or twice to activate the 'Switch
3
off after' function (see figure 16).
[17] 'Automatic switch-off' function.
Configuration management
33
Advertisement
Table of Contents
