Table of Contents
Advertisement
Defining the low power time (Eco only)
If the copier is not used for some time, it will switch to low power mode. The
low power screen is then shown on the display. The low power time is set by
default to 15 minutes, in order to comply with the EPA Energy Star criteria (see
page 140). This setting can be changed to a time between 1 and 15 minutes.
The machine will automatically go to low power mode after the specified
Note:
time. However, if a user takes any action during this time (such as placing an
original, opening a door or pressing a button) the timer is reset and starts
counting again.
You can activate the machine by sending an automatic print job or by pressing
a button on the console. The energy saving screen will disappear. The message
'Please wait' will appear and within 8 seconds the machine will show 'Ready
to copy' again. You can make settings for your next job during this waiting
time.
Changing the low power time
Access the key operator system (see page 14).
1
Open the 'Machine' section and select the 'Basic' settings.
2
Press the 'Power Saving' function button once or twice to activate the 'Low
3
Power after' function (see figure 16).
[16] 'Low power function.
Use the higher and lower arrow buttons to set the time.
4
When ready, exit the key operator system.
5
A classic machine has no option for low power mode. You can only set
Note:
the switch off time.
32
Océ 31x5E Configuration and special maintenance
Advertisement
Table of Contents
