Table of Contents
Advertisement
Refilling staples
The Océ 31x5E staple unit is located at the front of the finisher. If desired, this
stapler can be unlatched, which will allow users to reload staples. If the stapler
is still latched and staples run out, a message will appear in the display asking
users to contact you (the key operator) to refill staples.
There are two different types of staple units: a 35-sheet stapler and a 50-sheet
stapler. The Océ 3165E can be equipped with either one of these two, the
Océ 3145E and Océ 3155 always use the 50-sheet stapler. If you do not know
which type of stapler you have in your Océ 3165E, follow steps 1 through 3 in
the procedure below and check if the lid of the stapler looks like the one in
figure 69 on page 93. Then proceed from step 4 onward in the appropriate
procedure (35 sheet stapler or 50 sheet stapler).
New staples are available in special cartridges. Use S2 staples for the 50-sheet
stapler (order No. 29701443). For the 35-sheet stapler, use staples with order
No. 29701447.
Refill staples (35 sheet stapler)
Open the paper compartment door.
1
Slide the frame to the right with the blue handle marked 'A'.
2
[67] Sliding the frame of the paper compartment to the right
92
Océ 31x5E Configuration and special maintenance
Advertisement
Table of Contents
