The Operating Panel - Oce 7050 User Manual

The operating panel

The operating panel (see the illustration on inside back cover) on the
Océ 7050/7051 is easy to use and specially designed to carry out copy jobs.
After switching on, see page 9, the machine is always ready for operation. The
operating panel on the Océ 7050/7051 with manual roll will show blinking
LEDs on the display, to indicate that the machine is ready for operation. In this
state, the operating panel is in stand-by mode. The operating panel activates in
the following situations:
you feed an original
you feed a copy material
a button on the operating panel is pressed
If you do not work with the operating panel for more than 2 minutes, it
Note:
returns automatically to stand-by mode. The Océ 7050/7051, however, remains
always ready for operation.
Stop button
without finishing the current job. The original and the copy material remain in
the copier.
Exposure scale (lighter / darker)
'lighter' and 'darker' buttons. The exposure scale can be changed at all times.
Copy material selection button (film / paper)
the copy material. Your selection, paper or film, influences the fusing
temperature. All materials, except for film, should be copied in the 'paper'
setting.
Copy quantity selection button (Océ 7051 only)
increase or decrease the number of copies, as shown in the copy quantity
display. The copy quantity can be changed at all times.
Correction button (Océ 7051 only)
By pressing the correction button twice, all settings will reset to the standard
settings (see 'Standard settings' on page 42).
Display selection button (Océ 7051 with manual roll only)
'display selection' button, you can determine what will be shown on the
Introduction
The stop button stops the current copy process immediately
You modify the exposure scale with the
You can use this button to select
Press these buttons to
Resets the copy quantity counter to '1'.
By pressing the
7