Removal 30 Machine Control Unit (Pl9.1.20) - Dell 3130cn Service Manual

Removal 30 MACHINE CONTROL UNIT (PL9.1.20)

Never fail to perform the diagnostic operation described below. Otherwise the data will be
lost in the worst case.
Use a wristband to protect the PWB from electrostatic damage.
1) Perform NVM Save to evacuate the MCU data.
2) Turn on the power while pressing the
3) Enter the password, press the
comes up.
4) Press the
5) Press the
6) Press the
7) Press the
8) After SaveNVM to ESS is complete, press the [CANCEL] key several times until "IOT Diag" is
displayed.
9) Press the
10) Press the
11) Turn off the power.
12) Remove the POWER CORD from the AC outlet.
Steps 13 through 18 are for reference. Before removing this component, check that Steps 13 through
18 have been performed.
13) Remove the FUSER. (Removal 8)
14) Remove the REAR COVER. (Removal 10)
15) Remove the RIGHT COVER. (Removal 11)
16) Remove the LEFT COVER. (Removal 20)
17) Remove the SHIELD ASSY ESS. (Removal 25)
18) Remove the SHIELD MCU. (Removal 27)
Continues to the next page.
Version 1 2008.01.08
key several times until "IOT Diag" is displayed. Press the
key several until "NVM Settings" is displayed. Press the
key several times until "SaveNVM to ESS" is displayed. Press the
key twice, and SaveNVM to ESS is performed.
key several times until "Complete" is displayed.
key three times. "Ready to Print" is displayed.
Chapter 3 Removal and Replacement Procedures (RRPs)
key, key, and [MENU] key on the control panel.
key twice, and press the
3 - 54
key once. The diagnostic screen
key once.
key once.
key once.