Fip-1.P2 Blank Print (No Print) - Dell 3130cn Service Manual

FIP-1.P2 Blank print (No print)

Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the blank print.
1 Print the Contamination Check page.
Is the image printed correctly?
Checking the print cartridge installation.
2
Is the installed print cartridge the DELL cartridge?
Checking the paper
3
Is the installed paper with a new and dry one?
Checking the Test Pattern.
4 Is the image printed correctly?
Checked by [Test Print] - [Test Pattern 600] in diagnosis.
Checking the laser beam path.
5 Are there any foreign substance between the ROS ASSY
and the drum?
Checking the connection of the ROS ASSY.
6 Reseat the connector (P/J 151) of the ROS ASSY.
Is the image printed correctly?
Checking the TRANSFER ASSY installation
7 Reseat the TRANSFER ASSY.
Is the image printed correctly?
Version 3 2008.05.30
Trouble substance
The entire paper is printed pure white.
Possible causative parts
- TRANSFER ASSY (PL4.1.1)
- DISPENSER ASSY (PL5.1.12)
- HVPS (PL5.1.17)
- CARTRIDGE ASSY (PL5.1.18(K)/PL5.1.19 (C)/PL5.1.20 (M)/PL5.1.21 (Y))
- KIT ROS ASSY (PL5.1.99)
- PWBA MCU (PL9.1.20)
- PWBA ESS (PL9.1.27)
Check
1 - 290
Chapter 1 Troubleshooting
Yes
Check the print
data which the
problem gener-
ated.
DELL cartridge
Go to step 3.
Print]-[Toner Pal-
let Check] in diag-
Go to step 4. paper with a new
Replace the
PWBA ESS.
(Refer to Removal
26/Replacement
18)
Remove the for-
eign substance
End of work.
End of work.
No
Go to step 2.
Replace to the
and print ten
sheets [Test
nosis.
Replace the
and dry.
Go to step 5.
Go to step 6.
Go to step 7.
Go to step 8.