Replacement 27 Feed Drive Assembly (Pl8.1.7) - Dell 3130cn Service Manual

Replacement 27 FEED DRIVE ASSEMBLY (PL8.1.7)

1) Engage the connector (P/J251) of the FEED DRIVE ASSEMBLY.
2) Engage the BEARING of the FEED DRIVE ASSEMBLY with the shaft of the ROLL REGI
RUBBER (PL3.2.7), and then attach the FEED DRIVE ASSEMBLY to the printer.
3) Secure the FEED DRIVE ASSEMBLY to the printer using the three screws (silver, tap,
10mm).
4) Mate the one hole on the PLATE EARTH DRV MP with the boss on the PHOTOCONDUC-
TOR (PC) / DEVELOPER (DEV) DRIVE.
5) Secure the PLATE EARTH DRV MP to the PHOTOCONDUCTOR (PC) / DEVELOPER (DEV)
DRIVE and FEED DRIVE ASSEMBLY using the one screw (silver, 6mm) and the one screw
(silver, tap, 10mm).
Continues to the next page.
Version 3 2008.05.30
Chapter 3 Removal and Replacement Procedures (RRPs)
2)
3)
3 - 149
1)
4)
5)
5)
3)
3)
Zna03078KB