Fip-1.P3 Solid Black - Dell 3130cn Service Manual

FIP-1.P3 Solid black

Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the solid black.
1 Print the Contamination Check page.
Is the image printed correctly?
Checking the print cartridge installation.
2
Is the installed print cartridge the DELL cartridge?
Checking the paper
3
Is the installed paper with a new and dry one?
Checking the Test Pattern.
Print the Test Pattern page.
4
Is the image printed correctly?
Checked by [Test Print] - [Test Pattern 600] in diagnosis.
Checking the Grid2.
Print the Grid2 page.
5
Is the solid color printed?
Checked by [Test Print] - [Grid2] in diagnosis.
Checking the PWBA MCU installation Reseat the PWBA
6 MCU. (Refer to Removal 30/Replacement 14.)
Is the image printed correctly?
Version 3 2008.05.30
Trouble substance
The entire paper is printed jet-black.
Possible causative parts
- HVPS (PL5.1.17)
- CARTRIDGE ASSY (PL5.1.18(K)/PL5.1.19(C)/PL5.1.20 (M)/PL5.1.21 (Y))
- KIT ROS ASSY (PL5.1.99)
- PWBA MCU (PL9.1.20)
- PWBA ESS (PL9.1.27)
Check
1 - 292
Chapter 1 Troubleshooting
Yes
Check the print
data which the
problem gener-
ated.
DELL cartridge
Go to step 3.
Print]-[Toner Pal-
let Check] in diag-
Go to step 4. paper with a new
Replace the
PWBA ESS.
(Refer to Removal
26/Replacement
18)
Replace the toner
cartridge of the
color by which
Solid was printed.
End of work.
No
Go to step 2.
Replace to the
and print ten
sheets [Test
nosis.
Replace the
and dry.
Go to step 5.
Go to step 6.
Go to step 7.