Removal 12 LEVER FUSER D (PL6.1.18)
Steps 1 through 4 are for reference. Before removing this component, check that Steps 1 through 4
have been performed.
1)
Open the FRONT COVER (PL1.2.1).
2)
Remove the FUSER. (Removal 8)
3)
Remove the REAR COVER. (Removal 10)
4)
Remove the RIGHT COVER. (Removal 11)
5)
5)
Remove the one screw (silver, with flange, tap, 10mm) that fixes the LEVER FUSER D
(PL6.1.18) to the printer.
6)
Remove the LEVER FUSER D from the printer.
Version 3 2008.05.30
6)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 19
Zna03200KB