Removal 29 HUMIDITY SENSOR (PL9.1.19)
Steps 1 through 7 are for reference. Before removing this component, check that Steps 1 through 7
have been performed.
1)
Open the FRONT COVER (PL1.2.1).
2)
Remove the FUSER. (Removal 8)
3)
Remove the REAR COVER. (Removal 10)
4)
Remove the RIGHT COVER. (Removal 11)
5)
Remove the LEFT COVER. (Removal 20)
6)
Remove the SHIELD ASSY ESS. (Removal 25)
7)
Remove the SHIELD MCU. (Removal 27)
8)
Release the hook of the SPACER (PL9.1.18), and then remove the HUMIDITY SENSOR from
the printer.
9)
Disengage the connector (P/J261) of the HUMIDITY SENSOR (PL9.1.19).
Version 1 2008.01.08
Chapter 3 Removal and Replacement Procedures (RRPs)
8)-1
3 - 53
8)-2
9)
Zna03041KA