Removal 36 ROS (PL5.1.99)
12) Disengage all the connectors of the LOW VOLTAGE POWER SUPPLY (PL9.1.4), and then
release the harness from the clamps.
13) From the SHIELD LVPS, remove the clamp that fixes the harness of the INTERLOCK
SWITCH (PL9.1.3) and the clamp that fixes the harness of the HARN ASSY AC IN (PL9.1.16).
14) Remove the six screws (silver, 6mm), the two screws (silver, tap, 8mm) and the two screws (sil-
ver, tap, 10mm) that fix the LVPS ASSY (PL9.1.40) to the printer.
15) Release the three holes of the SHIELD LVPS from the bosses of the printer, lift the LVPS
ASSY up and remove it.
Continues to the next page.
Version 3 2008.05.30
13)-1
13)-2
12)
12)
13)-1
(P48)
15)
14)
14)
14)
Chapter 3 Removal and Replacement Procedures (RRPs)
(P501)
12)
(P44)
(P502)
(P47)
14)
14)
14)
14)
3 - 67
(P504)
12)
(P503)
(P40)
14)
14)
14)
Zna03220KB