Chapter 1 Troubleshooting Contents; Fip1.38 Paper Jam 077-104/077-107 - Dell 3130cn Service Manual

FIP1.33 Paper Jam 071-100
Step
Possible causative parts:
HARN ASSY REGI SNR (PL3.2.37)
HARN ASSY R SIDE (PL10.1.15)
SENSOR PHOTO (REGI SENSOR) (PL3.2.30)
PWBA MCU (PL9.1.20)
CLUTCH ASSY PH FEED (PL3.2.24)
DRIVE ASSY PH (PL8.1.7)
Checking the paper condition
1
Is the paper in the Tray wrinkled or damaged?
Checking the paper size setup
2 Does the paper size in use match the size setup set
through the control panel?
3 Does the error still occur when printing?
Checking after reseating the Paper Cassette
4 Reseat the Paper Cassette.
Does the error still occur when printing?
Checking the paper transfer path
Check if there are any stains or obstacles on the paper
5
transfer path.
Are there any obstacles on the paper transfer path?
Checking the SENSOR PHOTO (REGI SENSOR) for oper-
ation
Does the number on the screen increase by one, every
6 time the actuator of the SENSOR PHOTO (REGI SEN-
SOR) is operated?
Checked by [Digital Input] - [DI-3(Control Panel)/REGI
SNR(PC)] in diagnosis.
Checking the DRIVE ASSY PH for operation
Does the DRIVE ASSY PH operate properly?
7
Checked by [Digital Output] - [DO-a(Control Panel)/PH
MOTOR(FULL)(PC)] in diagnosis.
Checking the CLUTCH ASSY PH FEED for operation
Does the CLUTCH ASSY PH operate properly?
8
Checked by [Digital Output] - [DO-2f(Control Panel)/
CASSETTE1 FEED CLUTCH ON(PC)] in diagnosis.
Checking the connectors of the SENSOR PHOTO (REGI
SENSOR) for connection
9 Check the connections between the PWBA MCU and
REGI SENSOR.
Are P/J29, P/J292 and P/J2922 connected surely?
Version 1 2008.02.15
Check
1 - 213
Chapter 1 Troubleshooting
Yes
Replace the
paper with a new
and dry one, then
go to step 2.
Correct the paper
size through the
Go to step 3.
then go to step 3.
Go to step 4.
Go to step 5.
Remove the
obstacles or
stains from the
paper transfer
path.
Go to step 7.
Go to step 8.
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)
Go to step 10.
and/or P/J2922
No
Go to step 2.
control panel,
End of work
End of work
Go to step 6.
Go to step 9.
Go to step 14.
Go to step 17.
Reconnect the
connector(s)
P/J29, P/J292
surely.