Fip-1.P10 Afterimage (Ghost) - Dell 3130cn Service Manual

FIP-1.P10 Afterimage (Ghost)

Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step
Checking the paper condition
1
Is the paper dry and recommended paper?
2 Is the image printed correctly?
Checking the Afterimage(Ghost).
Print the Ghost Configuration Page.
3 Is the image printed correctly?
Checked by [Ghost Configuration Chart ] of the [Diagnosis]
tab in Tool Box.
Checking the Refresh Configuration page.
Checked by [PHD Refresh Configuration Chart ] of the
4
[Diagnosis] tab in Tool Box.
Is the image printed correctly?
Checking the surface of the TRANSFER ASSY
5 Are there any damages on the surface of the TRANSFER
ASSY?
Checking the TRANSFER ASSY for installation
6 Reseat the TRANSFER ASSY.
Is the image printed correctly?
Version 3 2008.05.30
Afterimage
Wsb02020KA
Check
Trouble substance
The ghost appears on the paper. The
ghost may be the image of the
previous page, or a part of the page
currently printing.
Possible causative parts
- TRANSFER ASSY (PL4.1.1)
- CARTRIDGE ASSY (PL5.1.18(K)/
PL5.1.19(C)/PL5.1.20 (M)/PL5.1.21
(Y))
- FUSER ASSY (PL6.1.10)
Mnt01114KA
Go to step 3.
End of work.
Check the print
data which the
problem gener-
End of work.
Replace the
TRANSFER
ASSY. (Refer to
Replacement 40)
End of work.
1 - 306
Chapter 1 Troubleshooting
Yes
Replace the
paper with a new
dry and recom-
mended one, then
go to step 2.
Go to step 3.
Go to step 4.
ated.
Go to step 5.
Go to step 6.
Removal 4/
Go to step 7.
No