Removal 17 Feed Drive Assembly (Pl8.1.7) - Dell 3130cn Service Manual

Removal 17 FEED DRIVE ASSEMBLY (PL8.1.7)

Steps 1 through 4 are for reference. Before removing this component, check that Steps 1 through 4
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 10)
4) Remove the RIGHT COVER. (Removal 11)
5) Remove the SPRING FEED MSI (PL3.1.4) from the printer.
6) Remove the GEAR MSI (PL3.1.5) from the SHAFT MSI (PL3.1.12) by releasing the hook on
the GEAR MSI.
7) Remove all the harnesses from the DUCT ASSY DRV PH (PL8.1.8).
Continues to the next page.
Version 1 2008.01.08
Chapter 3 Removal and Replacement Procedures (RRPs)
6)-1
3 - 30
5)
6)-2
Zna03017KA