Fip1.24 010-377 Restart Printer - Dell 3130cn Service Manual

FIP1.24 010-377 Restart Printer

Step
Possible causative parts:
FUSER ASSY (PL6.1.10)
HARN ASSY FUSER (PL6.1.11)
HARN ASSY LV TOP (PL10.1.16)
LVPS (PL9.1.4)
PWBA MCU (PL9.1.20)
Checking the FUSER ASSY for installation
1
Is the FUSER ASSY installed correctly?
2 Does the error still occur when the power is turned ON?
Checking the connectors for connection
Remove the FUSER ASSY.
Check the connections between the PWBA MCU and
FUSER ASSY.
Warning: Start the operation after the FUSER ASSY
has cooled down.
3
Check the connections between the FUSER ASSY and
LVPS.
Check the connections between the LVPS and PWBA
MCU.
Are P/J17, P/J171, P/J47, P/J501and P/J13 connected
surely?
Checking the HARN ASSY FUSER for continuity
Remove the FUSER ASSY.
Warning: Start the operation after the FUSER ASSY
4 has cooled down.
Disconnect P/J17 from the PWBA MCU.
Disconnect P/J171 from the FUSER ASSY.
Is each cable of P/J17 <=> P/J171 continuous?
Checking the HARN ASSY LV TOP for continuity
Disconnect P/J171 from the FUSER ASSY.
Disconnect P/J47 and 501 from the LVPS.
5
Disconnect P/J13 from the PWBA MCU.
Is each cable of P/J47 <=> P/J171 continuous?
Is each cable of P/J501 <=> P/J13 continuous?
Checking after replacing the FUSER ASSY
Replace the FUSER ASSY. (Refer to Removal 8/Replace-
ment 36)
6
Warning: Start the operation after the FUSER ASSY
has cooled down.
Does the error still occur when the power is turned ON?
Checking after replacing the LVPS
7 Replace the LVPS. (Refer to Removal 35/Replacement 9)
Does the error still occur when the power is turned ON?
Version 1 2008.02.15
Check
1 - 204
Chapter 1 Troubleshooting
Yes
Go to step 2. FUSER ASSY,
then go to step 2.
Go to step 3.
P/J17, P/J171,
Go to step 4.
then go to step 4.
Go to step 5.
Go to step 6. HARN ASSY LV
Go to step 7
Replace the
PWBA MCU.
(Refer to Removal
30/Replacement
14)
No
Reseat the
End of work
Reconnect the
connector(s)
P/J47, P/J501
and/or P/J13
surely,
Replace the
HARN ASSY
FUSER.
Replace the
TOP.
End of work
End of work