Removing And Installing The Primary Compact Flash Disk; Removing The Primary Compact Flash Disk - Juniper J2300 Getting Started Manual

Services router
Hide thumbs Also See for J2300:
Table of Contents

Advertisement

5.
6.
7.
NOTE: In the
an FPC number and the PIM number (always 0) is reported as a PIC number.

Removing and Installing the Primary Compact Flash Disk

The primary compact flash drive is located in a slot at the rear of the Services
Router as shown in Figure 2, Figure 8, and Figure 10. The primary compact flash
disk provides primary storage for the router. It can accommodate software images,
configuration files, and microcode.
For information about configuring the primary compact flash disk, see the J-series
Services Router Administration Guide.
To remove and install a primary compact flash disk, perform the following
procedures:

Removing the Primary Compact Flash Disk

To remove the primary compact flash disk (see Figure 58):
1.
2.
Repeat the previous steps for any additional cables.
If the PIM is offline (its status LED is steadily red), issue the following CLI
command to bring the PIM online:
user@host> request chassis pic fpc-slot pim-slot pic-slot 0 online
For example, to bring the PIM in slot 4 online, enter the following command:
user@host> request chassis pic fpc-slot 4 pic-slot 0 online
For more information about the command, see the JUNOS System Basics
and Services Command Reference.
Verify that the PIM status LED shines steadily green to confirm that the PIM
is online.
You can also verify correct PIM functioning by issuing the
command described in the JUNOS System Basics and Services
pic-status
Command Reference.
show chassis fpc pic-status
Removing the Primary Compact Flash Disk on page 169
Installing the Primary Compact Flash Disk on page 170
Place an electrostatic bag or antistatic mat on a flat, stable surface.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
Replacing and Troubleshooting Hardware Components
command, the PIM slot number is reported as
Replacing Hardware Components
show chassis fpc
169

Advertisement

Table of Contents
loading

This manual is also suitable for:

J4300J6300

Table of Contents