Tri-Fold Position Adjustment - Konica Minolta bizhub C650 User Manual

Utility mode
– Each time [+] or [-] is touched, the value is increased or decreased by one increment.
– If the folding position is too far to the right of the center of the paper, touch [-] to reduce the
adjustment (between -0.1 mm and -12.8 mm).
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The center folding position is adjusted.
If the folding position was at the center of the paper in step 7, this completes the procedure.
9
Use the "Half-Fold" setting to print another sample copy.
10
Check the print result.
– Check that the folding position is adjusted to the center of the paper.
– If more adjustment is necessary, repeat steps 6 through 9.
Note
Set the value by mm. Refer to the conversion rate below. 1 inch = 25.4 mm

Tri-Fold Position Adjustment

The folding position when printing with the "Tri-Fold" setting can be adjusted for each paper size.
Note
[Tri-Fold Position Adjustment] does not appear if optional Finisher FS-608 is not installed.
0 Before making any adjustments, use the "Tri-Fold" setting to print a single sample copy. Perform the
adjustment while checking the sample that was created.
1
Display the Administrator Settings screen.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
C650
11
11-53