Konica Minolta bizhub C650 User Manual page 474

Utility mode
6
Touch the button for the paper tray to be set.
7
Press the [Start] key.
– Only paper loaded into the bypass tray can be used.
A test pattern is printed.
8
Check that the distance from the starting print position of the test pattern to the edge of the paper (b)
is 3 mm (±0.5 mm).
– If the distance is 2.4 mm or less, touch [+] to increase the adjustment (between 0.2 mm and 3.0 mm).
– If the distance is 3.6 mm or more, touch [-] to reduce the adjustment (between -0.2 mm and -3.0
mm).
– If the distance is between 2.5 mm and 3.5 mm, continue with step 10.
– Each time [+] or [-] is touched, the value is increased or decreased by one increment.
9
Press the [Start] key.
The adjusted test pattern is printed.
10
Adjust the distance from the starting print position of the test pattern to the edge of the paper.
– Check that the distance has been adjusted to between 2.5 mm and 3.5 mm.
– If more adjustment is necessary, repeat steps 8 and 9.
– To adjust the print position for a different paper tray, return to step 6.
11
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The print position is adjusted.
Note
Set the value by mm. Refer to the conversion rate below. 1 inch = 25.4 mm
C650
b
b: 3.0 mm ± 0.5 mm
11
11-43