Names Of Control Panel Parts; Finishing - Konica Minolta bizhub C650 User Manual

Basic copy operations
!
Detail
When manually performing the hole-punching operation from the post inserter control panel, only two
holes can be punched.

Names of control panel parts

Finishing

1
Load the paper into the lower tray of the post inserter.
– If the "Corner" or "2 Position" Staple settings are to
be used, load the paper face up
– If a Punch setting is to be used, load the paper face
up.
– If the paper is to be stapled and folded at the center,
load the paper so that the side that is to be the front
when bound is face up.
– If the paper is to be folded in three, load the paper so
that the side that is to be the outside when folded in
three is face up.
2
Slide the paper guides to fit the size of the paper.
3
Press the [Finishing] key or [Punch] key, and then select the desired Finishing settings.
– When the "Corner" or "2 Position" Staple settings, or the "Center Staple & Fold" or "Tri-Fold" setting
is selected, press the [Finishing] key, and the indicator lights up. When a Punch setting is selected,
press the [Punch] key, and the indicator lights up.
– A Punch can be selected at the same time as the "Corner" or "2 Position" Staple setting. If the
settings are selected at the same time, the indicator lights up when the [Finishing] key is pressed.
When only a Punch setting is selected, all indicators except the one on the [Punch] key go off.
C650
Center Staple & Fold
Corner Staple
[Finishing] key
2 Position Staple
Tri-Fold
[Punch] key
[Start/stop] key
2
2-74