Konica Minolta bizhub C650 User Manual page 259

Copy paper/original documents
4
Touch [Custom Size].
The Custom Size screen appears.
5
Type in the length (X) and width (Y) of the paper.
– Make sure that [X] is selected, touch [↔] to switch between the integer and the fraction, and then
touch [–] and [+] to type in the length of side X. (5-1/2 inch to 18 inch)
– Make sure that [Y] is selected, touch [↔] to switch between the integer and the fraction, and then
touch [–] and [+] to type in the length of side Y. (3-9/16 inch to 12-1/4 inch)
– If a decimal value is displayed in the Custom Size screen, use the keypad to type in the setting. For
details on switching between decimal and fraction values, refer to "System Settings" on
page 11-15.
– If a decimal value is displayed in the screen and the specified value is outside the allowable range,
the message "Input Error" appears. Type a value within the allowable range. If the value was
incorrectly entered, press the [C] (clear) key to erase the value, and then specify the correct value.
To cancel changes to the settings, touch [Cancel].
Can paper sizes be stored?
?
% Five non-standard paper sizes can be stored.
% To recall a stored paper size, touch the corresponding memory key.
% The names "memory1" through "memory5" can be changed. For details on changing the names,
refer to "Storing a non-standard paper size (Custom Size settings)" on page 6-11.
% For details on storing paper sizes, refer to "Storing a non-standard paper size (Custom Size
settings)" on page 6-11.
6
Touch [OK], and then touch [OK] in the next two screens that appear.
The Basic screen appears again.
C650
6
6-10