Utility mode
–
If the lines are shifted in the Y direction as shown below, touch [+] under "Y" to increase the
adjustment (between 1 dot and 6 dots).
–
If the lines are not shifted from the reference lines, continue with step 10.
9
Press the [Start] key.
–
The adjustment is applied when the [Start] key is pressed. To cancel the adjustment, press the
[Reset] key instead of pressing the [Start] key.
The adjusted test pattern is printed.
10
Check the print result.
–
If there is no shift between the black and cyan lines, continue with step 11.
–
If more adjustment is necessary, repeat steps 8 and 9.
11
Touch [OK].
–
To cancel the setting and select the default, press the [Reset] key.
C650
11
11-63