Konica Minolta bizhub C650 User Manual page 212

Troubleshooting
5
Open the upper door.
6
Lift up paper take-up roller, and then remove any paper
remaining in the tray.
7
Load the paper into the tray again, lower the paper take-up roller, and then close the tray.
Reminder
When removing misfed paper, remove it without lifting the paper take-up roller.
Be careful not to touch the surface of the paper take-up roller with your hand.
Clearing a paper misfeed in Finisher FS-517
This procedure describes the operations to be performed along the paper path where paper misfeeds may
occur.
Depending on the selected Finishing settings, the paper path changes, resulting in different locations in the
finisher where paper misfeeds may occur.
1
Open the cover for the horizontal transport unit, and then
remove any misfed paper in the horizontal transport unit.
– Do not forcefully push or pull the sensor pin in the
horizontal transport unit, otherwise the horizontal
transport unit may be damaged.
C650
Sensor pin
4
4-35