Toyota T100 1996 Service Manual page 1336

Removal
1996 TOYOTA T100 (RM449U)
MANUAL TRANSMISSION (W59)
D10958
Installation
Q06720
WM0041
− MANUAL TRANSMISSION ASSEMBLY
(l) Pull out the No.4 shift fork shaft.
(m) Remove the pin from the reverse shift head.
HINT:
At the time of reassembly, please refer to the following item.
Apply MP grease to the pin.
(n) Remove the No.3 shift fork, fork shaft and reverse shift
arm with the snap ring.
HINT:
At the time of reassembly, please refer to the following item.
Align the No.3 shift fork with the No.3 hub sleeve groove, put
the reverse shift arm into the pivot of bearing retainer and align
the reverse shift arm shoe with the reverse idler gear groove.
14. REMOVE SPEEDOMETER DRIVE GEAR
Pry out both ends of the clip and remove the drive gear.
15. INSPECT COUNTER 5TH GEAR THRUST CLEAR-
ANCE
Using a feeler gauge, measure the counter 5th gear thrust
clearance.
Standard clearance:
0.10 − 0.41 mm (0.0039 − 0.0161 in.)
Maximum clearance:
0.46 mm (0.0181 in.)
MT−11