Toyota T100 1996 Service Manual page 1434

TR−26
A
1996 TOYOTA T100 (RM449U)
TRANSFER
INSPECTION
1.
B
Using a micrometer, measure the outer diameter of the rear out-
put shaft journal surface.
Q09962
2.
Using a dial indicator, measure the radial clearance between
the sprocket and shaft with the needle roller bearing installed.
If the clearance exceeds the maximum, replace the drive
sprocket, rear output shaft or needle roller bearing.
TF0522
3.
Using a feeler gauge, measure the clearance between the front
drive shift fork and hub sleeve.
If the clearance exceeds the maximum, replace the shift fork or
hub sleeve.
TF0523
4.
Using a feeler gauge, measure the clearance between the high
and low shift fork and hub sleeve.
If the clearance exceeds the maximum, replace the shift fork or
hub sleeve.
TF0524
− REAR OUTPUT SHAFT
INSPECT REAR OUTPUT SHAFT
Minimum diameter:
Part A: 27.98 mm (1.1016 in.)
Part B: 36.99 mm (1.4563 in.)
INSPECT DRIVE SPROCKET RADIAL CLEARANCE
Standard clearance:
0.010 − 0.055 mm (0.0004 − 0.0022 in.)
Maximum clearance: 0.055 mm (0.0022 in.)
INSPECT FRONT DRIVE SHIFT FORK AND HUB
SLEEVE CLEARANCE
Maximum clearance: 1.0 mm (0.039 in.)
INSPECT HIGH AND LOW SHIFT FORK AND HUB
SLEEVE CLEARANCE
Maximum clearance: 1.0 mm (0.039 in.)
TR023−02