Toyota T100 1996 Service Manual page 1288

MT−8
MANUAL TRANSMISSION (R150, R150F)
1996 TOYOTA T100 (RM449U)
− MANUAL TRANSMISSION UNIT (4WD)
8. REMOVE FRONT EXHAUST PIPE
(a) Remove the 2 nuts, gasket and oxygen sensor.
(b) Remove the 2 bolts, retainer and gasket.
Torque: 48 N·m (490 kgf·cm, 35 ft·lbf)
Q06824
(c) Remove the 3 bolts and bracket.
Torque: 44 N·m (450 kgf·cm, 33 ft·lbf)
(d) Remove the 3 nuts, front exhaust pipe and 2 gaskets.
Torque: 62 N·m (630 kgf·cm, 46 ft·lbf)
9. REMOVE STARTER
(a) Disconnect the connector and wire from the starter.
(b) Remove the 2 bolts and starter.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Q06823
10. REMOVE STIFFENER PLATE (RH AND LH) AND
REAR END PLATE
Remove the 8 bolts, stiffener plate (RH and LH) and rear end
plate.
Torque: 37 N·m (380 kgf·cm, 27 ft·lbf)
11. REMOVE STABILIZER BAR (See page SA−126)
12. JACK UP TRANSMISSION SLIGHTLY
Using a transmission jack, support the transmission.
13. REMOVE CROSSMEMBER
Q06822
(a) Remove the 4 set bolts of the engine rear mounting.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
(b) Remove the 8 bolts and crossmember.
Torque: 95 N·m (970 kgf·cm, 70 ft·lbf)
14. REMOVE TRANSMISSION WITH TRANSFER
(a) Remove the 6 transmission mounting bolts from the en-
gine.
Torque: 72 N·m (730 kgf·cm, 53 ft·lbf)
(b) Disconnect the 3 wire clamps from the transmission.
(c) Pull out the transmission with the transfer down and to-
ward the rear.
15. REMOVE ENGINE REAR MOUNTING
Remove the 4 bolts and engine rear mounting.
Q10111
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)