Toyota T100 1996 Service Manual page 1138

Recommended Viscosity (SAE):
10W−30
5W−30 PREFERRED
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
SST
Oil Pressure Gauge
1996 TOYOTA T100 (RM449U)
LUBRICATION (5VZ−FE) −
OIL AND FILTER
INSPECTION
1. CHECK ENGINE OIL QUALITY
Check the oil for deterioration, entry of water, discoloring or thin-
ning.
If oil quality is visibly poor, replace it.
Oil grade:
API grade SH Energy−Conserving II or ILSAC multi-
LU0817
grade engine oil.
SAE 5W−30 is the bset choise for your vehicle, for
good fuel economy, and good starting in cold
weather.
2. CHECK ENGINE OIL LEVEL
The oil level should be between the "L" and "F" marks on the dip-
stick.
3. CHECK OIL LEVEL
The oil level should be between the "L" and "F" marks on the lev-
el gauge. If low, check for leakage and add oil up to the "F" mark.
If low, check for leakage and add oil up to the "F" mark.
When inserting the oil dipstick, insert the curved tip of the
dipstick facing the same direction as the curve of the
guide.If the dipstick gets caught while inserting it, do not
force it in. Reconfirm the direction of the dipstick.
4. REMOVE OIL PRESSURE SWITCH
Using SST, remove the oil pressure switch.
SST
5. INSTALL OIL PRESSURE GAUGE
6. START ENGINE
Start the engine and warm it up to normal operating tempera-
ture.
P20966
7. CHECK OIL PRESSURE
Oil pressure:
At idle speed
29 kPa (0.3 kgf/cm
At 3,000 rpm
245 − 520 kPa (2.5 − 5.3 kgf/cm
8. REMOVE OIL PRESSURE GAUGE
P20969
OIL AND FILTER
09816−30010
2
, 4.3 psi) or more
Author :
LU−1
LU033−04
2
, 36 − 75 psi)
Date : 1121