Toyota T100 1996 Service Manual page 1466

Color
Drill Mark
Drill Mark
Bearing
Cap
SST
1996 TOYOTA T100 (RM449U)
PROPELLER SHAFT −
4. SELECT SPIDER BEARING
Select the appropriate bearing according to the existence of
drill mark on the yoke.
Yoke
R04421
5. INSTALL SPIDER BEARING
(a) Apply MP grease to the spider and bearings.
HINT:
Be careful not to apply too much grease.
(b) Align the matchmarks on the yoke and shaft.
Z00735
(c) Fit a new spider into the yoke.
(d) Using SST, install a new bearing on the spider.
SST
PR0027
(e) Using SST, adjust both bearings so that the snap ring
grooves are at maximum and equal in width.
PR0028
6. INSTALL SNAP RINGS
(a) Install 2 new snap rings of equal thickness which will allow
0 − 0.05 mm (0 − 0.0020 in.) axial play.
HINT:
Do not reuse the snap rings.
R16052
SPIDER BEARING
Yoke
With drill mark
No drill mark
09332−25010
Author :
PR−19
Bearing
With color mark (Red)
No color mark
Date : 1437