Toyota T100 1996 Service Manual page 1417

1996 TOYOTA T100 (RM449U)
TRANSFER
10. REMOVE EXTENSION HOUSING
(a) Remove the 5 bolts.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
HINT:
At the time of installation, apply liquid sealer to the bolts.
Sealant:
Part No.08833−00080, THREE BOND 1344,
LOCTITE 242 or equivalent
(b) Using a plastic hammer, tap the extension housing and
TF0453
remove it.
HINT:
FIPG
At the time of installation, please refer to the following items.
Remove any FIPG material and be careful not to drop oil
S
on the contacting surfaces of the extension housing.
Apply FIPG to the extension housing, as shown.
S
FIPG:
Part No.08826−00090,
THREE BOND 1281 or equivalent
F02979
11. REMOVE SPEEDOMETER DRIVE GEAR
(a) Remove the speedometer drive gear.
HINT:
At the time of installation, please refer to the following item.
Make sure to install the speedometer drive gear in the correct
direction.
(b) Using a magnetic finger, remove the ball from the rear out-
put shaft.
TF0454
12. SEPARATE FRONT CASE AND REAR CASE
(a) Remove the 12 bolts.
Torque: 28 N·m (285 kgf·cm, 20 ft·lbf)
(b) Using a plastic hammer, tap the rear case and separate
the front case and rear case.
TF0455
HINT:
At the time of installation, please refer to the following items.
FIPG
Shift the high and low clutch sleeve to low side (rear side)
S
and assemble the front case and rear case.
Remove any FIPG material and be careful not to drop oil
S
on the contacting surfaces of the rear case.
Apply FIPG to the rear case, as shown.
S
FIPG:
Part No.08826−00090,
Z14087
THREE BOND 1281 or equivalent
− TRANSFER ASSEMBLY
TR−9