Toyota T100 1996 Service Manual page 1415

1996 TOYOTA T100 (RM449U)
TRANSFER −
DISASSEMBLY
1. REMOVE SPEEDOMETER DRIVEN GEAR
Torque: 11 N·m (115 kgf·cm, 8 ft·lbf)
2. REMOVE TRANSFER INDICATOR SWITCH
Torque: 37 N·m (380 kgf·cm, 27 ft·lbf)
3. A/T:
REMOVE TRANSFER L4 AND NEUTRAL POSITION
SWITCH
Torque: 37 N·m (380 kgf·cm, 27 ft·lbf)
HINT:
At the time of installation, check the following items.
Check to see that the input shaft and output shafts rotate
S
smoothly.
Check to see that shifting can be made smoothly to all
S
position.
4. A/T:
REMOVE SHIFT GEAR HEAD NO.1 AND NO.2
(a) Using a pin punch and hammer, drive out the 2 slotted
spring pins.
(b) Remove the 2 shift gear heads.
TF0629
5. REMOVE FRONT RETAINER
(a) Remove the 7 bolts.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
HINT:
At the time of installation, apply liquid sealer to the bolts.
Sealant:
Part No.08833−00080, THREE BOND 1344,
LOCTITE 242 or equivalent
(b) Using a plastic hammer, tap the front retainer and remove
TF0447
it.
HINT:
At the time of installation, please refer to the following items.
FIPG
Remove any FIPG material and be careful not to drop oil
S
on the contacting surfaces of the front retainer.
Apply FIPG to the front retainer, as shown.
S
FIPG:
Part No.08826−00090, THREE BOND 1281,
LOCTITE 242 or equivalent
Q09400
TRANSFER ASSEMBLY
TR−7
TR0CZ−01